Overview
Clear Anti-Graffiti Paint is a one-pack, single-coat anti-graffiti paint that dries to a clear, graffiti-resistant film. It is designed to keep the texture, finish and colour of the surface on show, while letting you remove graffiti with water or mild detergent.
It is a permanent, non-sacrificial coating, so it stays in place through repeated cleaning. Facilities managers, councils and contractors use this graffiti-resistant paint on facades, exterior walls and street furniture where a clear finish is wanted rather than a coloured one. It also protects against fly-posters.
Why choose it
- Water-washable: graffiti comes off with water and detergent or gentle water pressure.
- Permanent: a non-sacrificial film that withstands repeated graffiti removal and cleaning.
- Clear finish: designed to keep the original look of the surface.
- Breathable: moisture vapour can pass through, so moisture isn’t trapped.
- Single pack, single coat: no mixing. Apply by brush, roller, conventional or airless spray.
- Fly-poster protection: guards against fly-posters as well as graffiti.
Where to use it
Use it on stone, brick, concrete, masonry, painted surfaces and similar architectural finishes, for example:
- painted facades and exterior walls
- sandblasted stone and brickwork (with a non-darkening primer, see below)
- street furniture and public spaces where clear protection is preferred
Not suitable for: hiding existing graffiti. It is clear, so remove marks first or re-paint them. To cover graffiti and protect in one job, use Coloured Anti-Graffiti Paint. For listed or heritage masonry, talk to the team first.
How to apply it
- Clean: the surface must be clean, dry and sound. Power-wash off any soiling.
- Deal with existing marks: on painted masonry or rendered walls, re-paint any soiling or graffiti with good-quality exterior masonry paint before you start.
- Prime brick and sandstone: apply a non-darkening primer before the top coat on all sandstone and brick surfaces.
- Apply: one coat by brush, roller, conventional or airless spray. Check the film coverage and rework any thin areas.
- Dry and cure: touch dry in 3–4 hours and fully cured in 24 hours. If a second coat is needed, recoat after 3–4 hours. Let it cure fully before exposing it to graffiti or cleaning.
How much do I need?
The data sheet gives a theoretical coverage of 8–10 m² per litre, so a 5 litre tin covers about 40–50 m² in one coat. Real coverage depends on the substrate and its porosity: Urban Hygiene sets the film thickness for your surface, normally 50–80 microns dry. Contact the team with your surface and area for a firm quantity.
Cleaning graffiti off it
Wash graffiti off with water and detergent, or use a recommended graffiti remover, then rinse or pressure-wash gently. The film is designed to endure many cleaning cycles without losing performance, so there is no need to re-coat after cleaning.
Good to know
- Patch-test first to check adhesion and appearance. The data sheet lists finishes from gloss to semi-matt, so check the sheen on your surface.
- One pack: there are no components to mix.
- Safety: it may cause an allergic skin reaction. Wear gloves and eye protection, avoid breathing vapour or spray, and work in a well-ventilated area. People prone to skin allergies should not handle it.
Need a colour instead? See Coloured Anti-Graffiti Paint. For a hard clear glaze with a proven 20-year life, see Anti-Graffiti Coating, or compare all anti-graffiti coatings.
Compare all our anti-graffiti paint and coatings.
